Address 01: Engine Labels: Redir Fail!
Part No SW: 4F0 910 401 F HW: 4F0 907 401 A
Component: 3.0L V6TDI G000AG 0050
Revision: --H01--- Serial number:
Coding: 0011772
Shop #: WSC 02297 264 67208
VCID: 1F46E122F1E7CAE4
4 Faults Found
19591 - Intake Manifold Runner Control: Lower Stop not Reached
P3135 - 001 - Upper Limit Exceeded - Intermittent
Freeze Frame:
RPM: 0 /min
Torque: 179.4 Nm
Speed: 0.0 km/h
Voltage: 12.16 V
Duty Cycle: 88.8 %
Duty Cycle: 20.5 %
Duty Cycle: 20.5 %
Temperature: 91.8°C
17426 - Intake Manifold Runner (Bank 2): Lower limit not reached
P1018 - 001 - Upper Limit Exceeded
Freeze Frame:
RPM: 945 /min
Torque: 124.8 Nm
Speed: 0.0 km/h
Voltage: 13.68 V
Duty Cycle: 80.9 %
Duty Cycle: 88.8 %
Duty Cycle: 80.9 %
Temperature: 0.9°C
19804 - Control Circuit for Controller for Turbocharger 1 (J724): Electrical Malfunction
P3348 - 005 - No or Incorrect Basic Setting / Adaptation
Freeze Frame:
RPM: 0 /min
Torque: 234.0 Nm
Speed: 0.0 km/h
Temperature: 16.2°C
Voltage: 10.79 V
Voltage: 10.79 V
Duty Cycle: 88.8 %
Duty Cycle: 80.9 %
16955 - Brake Switch (F): Implausible Signal
P0571 - 001 - Upper Limit Exceeded - Intermittent
Freeze Frame:
RPM: 840 /min
Torque: 46.8 Nm
Speed: 6.7 km/h
Voltage: 13.68 V
(no units): 1.0
(no units): 1.0
Bin. Bits: 00000100
Bin. Bits: 00000100
Readiness: 0 1 0 0 0
По заслонкам две ошибки были, а по турбине и стоп-сигнал F, это новые. В чем может быть причина? Я их удалил, пока больше не появляются, но все равно стремно.
как исправить 
спасибо
